What are the reasons for the low heat transfer efficiency of plate heat exchangers
Post time:
2023-02-18
There are many reasons for the low heat transfer efficiency of the plate heat exchanger, because we all know that the plate heat exchanger heat transfer efficiency is very high, but also one of the reasons why we often choose.
With the use of more and more time, the heat transfer efficiency will inevitably be affected, thus affecting the positive production operation.
So it is important to understand the reasons for the low heat transfer efficiency of plate heat exchanger
The reasons for the low heat transfer efficiency of the plate heat exchanger can be divided into the following five points.
One, the material
The choice of the wrong material will affect the heat transfer area of the heat exchanger, many people in the selection, often choose a small heat transfer coefficient of plate heat exchanger, the correct choice of material when the heat transfer coefficient is large, the thermal resistance of small materials.
Second, the flow rate
Plate heat exchanger in the operation of the liquid flow rate differences will also affect the heat transfer efficiency, the side of the low flow rate will lead to wall fluid stagnation layer is too thick.
Three, operation and maintenance aspects
If you encounter heat exchanger scaling, remember to clean up in a timely manner, or it will affect the heat transfer effect.
Fourth, the temperature difference
A small temperature difference between the heat source and the cold source will affect the heat transfer efficiency.
V. Structure
In the structure may be unreasonable phenomenon, there will be cold, heat sources can not be fully contact with the heat exchanger area, resulting in a large local temperature difference between the heat exchanger, the heat transfer area can not be fully utilized.
These are the reasons for the low heat transfer efficiency of the plate heat exchanger, know the reasons after the good solution!
That how to improve the heat transfer efficiency of the plate heat exchanger, you can start from the following aspects.
First, choose a high thermal conductivity of the plate
Second, reduce the thermal resistance of the fouling layer
Third, increase the heat transfer efficiency
Fourth, reduce the heat exchanger gas resistance
The above points can improve the heat transfer efficiency of the heat exchanger, the article has been detailed in each step, as well as notes to explain, you can poke in for a closer look.
